Magnetic Bulk Tape Eraser
(440-0232)                 Operation                  Faxback Doc. # 37630


USING YOUR BULK ERASER

CAUTION:  This unit is designed for intermittent use - 1 minute on followed
          by 20 minutes off.  Do not exceed this limitation.  Erasing an
          entire tape takes only about 10 seconds or less.  So, after
          erasing about six tapes, you should let the unit cool off for
          about 20 minutes to prevent over heating and damage.

1.  Plug the power cord into a standard wall outlet.

2.  Hold the eraser by its handle and pull back the on/off switch to the on
    position with your thumb.

3.  While holding the button in the ON position, press the bottom of the
    eraser lightly on the cassette, tape reel, or diskette, and move the
    eraser in a circular motion across the entire surface of the media. 
    (Start in the middle of tape reels.)

     NOTE:  It takes only 7 to 10 seconds to completely erase a tape or
            diskette.

     DO NOT RELEASE THE ON/OFF BUTTON YET!

4.  While still holding the button in the ON position, slowly move the
    eraser away from the media.  When you are about 3 feet from the media,
    release the button.

To erase a magnetic track from movie film, position the film reel with the
magnetic track facing up and proceed as instructed on the previous page. 
This unit does not erase metal tapes.

WARNING:  To prevent fire or electrical shock, do not expose this appliance
          to rain or moisture.

CAUTION:  Do no use the Magnetic Bulk Tape Eraser near delicate electronic
          equipment such as pace makers or electronic watches.

(YO/km-01/30/1997)

Privacy Policy